![]() To get some bubbles and more cleaning power, some droplets of dishwasher detergent are a great addition. So, to remove grime, the first step is to fill the sink with warm water. This category includes buttons, knobs, slider tops, and keys.Ī warm, damp cloth is not enough to remove grime it needs to go a step further. This is especially true for those parts of the synth that receive the most use. Once you're completely done with the second part of step 1, you can repeat the first and dry it with a fine microfiber cloth to remove debris from the surface.ĭirt, combined with sweat, skin's natural oil, and repetition, can create grime. Furthermore, that might lower the synth's resale price. Having a plethora of blind controls to work with is not recommended. Just beware of the paint and labelling/lettering because alcohol might wipe them away too. If you notice any stubborn stains at a surface level, you can always use denatured alcohol with a piece of cotton to remove it. If any drop of water gets into the circuit board through the sliders, there could be serious consequences. For this step, it is paramount that you wrung out the water excess from the cloth. You can use water only or add a drop of detergent to it. This is a superficial cleaning that can take away all the visible accumulated dust.Īfter the initial dry wipedown, it is time to go for the damp cloth. Protecting a synthesizer is important protecting eyes and hands is even more important.Īfter you've deposited your synthesizer over a clean area, the first thing to do is to use a dry cloth and remove debris and dirt. Use Protectionįinally, when handling chemicals (like in step 5, for example), always wear gloves and use eye protection. The goal is to clean the synthesizer (of dust, mould, residue, etc.), so having a dirt-free workspace is essential. ![]() Accidentally mixing the loose synthesizer parts with other loose pieces, tools, etc., can lead to unnecessary difficulty in the long term.Īdditionally, ensure the working space is clean of its own debris. In this sense, having a large, clean surface will not only make the job easier but can also spare you more than a headache. This is especially important if you have little children or pets that might find it amusing to play with them.Īnother important precaution is to clean the area you'll be working in. Use receptacles to store each part you remove to prevent the scenario of not knowing where those small screws went. Use ReceptaclesĪnother complication that might arise for newbies is misplacing parts once removed. Take those extra seconds to avoid complications with reassembly and the potential damaging of your synth. Moreover, this approach has no limits you can take pictures several times within each step. ![]() To avoid it, snap a picture before every step, so you know for sure every part's position. Take Pictures At Every StepĪ very common mistake, especially with complex devices such as synthesizers, is not remembering what goes where. It is always better to err on the safe side. Furthermore, you can try them on a similar surface too.Īs a rule of thumb: If the product looks (or reads to be) harsh, abrasive, or damaging, it probably is. Thus, to avoid any bad chemical reactions, apply these products in a non-visible, non-essential part of the synth first. Try The Cleaning Products FirstĪlthough most of the products named in this blog post are safe, every synthesizer is different. Please read them carefully and try to apply them to every step to avoid common pitfalls.
0 Comments
Leave a Reply. |